Duex 5 Expansion Board

$104.99

Duex5 In stock, ready to ship.

Current Duex 5 version: v0.10.

The Duex 5 has the following features:

  • 5 additional TMC2660 stepper motor drivers with stall notification.
  • 5 additional extruder heater outputs.
  • 5 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters. So you can use unused heater channels to drive servos.
  • 5 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
  • 5 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
  • 4 uncommitted general purpose I/O pins.
  • 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
  • 5 additional thermistor inputs.
  • Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
  • Optional 5V external power input for powering servos, fans etc.
  • Includes 50 pin cable and connector kit. 

For more information see the Wiki.

As of May 12th, 2021, all Duet3D products purchased from Filastruder will be eligible for a 12 month limited warranty. For more information, visit http://www.duet3d.com/warranty.


    Next Previous