E3D Revo Voron

$89.99

– Sold Out
Options
Voltage

Sign up for restock notifications!

Please sign up to be notified once RapidChange Revo products are in stock and ready to ship. We are not taking pre-orders. You can expect Filastruder to have stock as soon as products are available anywhere.

Swap nozzles without complex tools and hot tightening with this innovative new HotEnd ecosystem from E3D, FDM 3D printing extrusion system experts.

We are proud to be a
US distributor for E3D.  

Smaller, lighter, and better than ever before, the Revo Voron HotEnd uses the smallest heatsink we’ve produced so far. Weighing in at only 25g, use Revo Voron to squeeze more speed performance from your motion system. Intended for direct drive setups, Revo Voron is fully compatible with the Revo ecosystem, so you can easily change nozzles without tools or hot tightening at room temperature, using just your fingers. With an anodized red heatsink, not only does Revo Voron run cool – it looks cool, too.
  • Designed for use with Revo Nozzles · Works with a Revo HeaterCore for faster heat-ups
  • Smallest and lightest HotEnd produced so far
  • Titanium-like performance
  • Ultra-lightweight construction for improved speed performance
  • Compatible with Voron Afterburner/Stealthburner, Legacy, Switchwire, Trident, Voron 0, Voron 1, Voron 2
  • Heatsink is licensed under GPLv3, full drawing available after units start shipping


Ready for Revo

Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.

Titanium-like performance

E3D's special manufacturing process gives this aluminum HotEnd the strength and low thermal conductivity of titanium, without actually being titanium!

New hotness

A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.

Runs cool, looks cool

With an anodized red heatsink, not only does Revo Voron run cool – it looks cool, too. 

Flexible to any setup

Revo Voron is intended for Voron printheads.

Key features
  • Low thermal conductivity in a compact space
  • Maximum temperature: 300C
  • Lightweight for greater motion system agility
  • Compatible with RapidChange Revo ecosystem
  • 4x M3 mounting (see drawing)
  • Compatible with direct drive systems
  • Mass: 25g
Kit Contains

Revo Micro HeatSink
Revo HeaterCore w/ spring
Revo Nozzle(s)

Voltage

12V or 24V

 

Photo credit: wile.e from Voron Discord