E3D Heater Block (Old Style, v6/Volcano)

Title

The v6 Heater Block has been upgraded to clamp both the heater cartridge and thermistor in place. These design improvements improve the thermal response of the HotEnd and make thermistor assembly easier.

This product also comes with the following fixings:

  • M3x0.5x4 socket dome screw and washer to clamp thermistor
  • M3x0.5x10 socket dome screw to clamp heater cartridge

This is the specialised heater block for our Volcano upgrade pack.

Compatible with all Volcano Nozzles and all E3D HotEnds except Cyclops. This block uses the same clamped thermistor mounting configuration as the E3D-v6 Heater Block for maximum ease of use and security. The block also has a heater cartridge clamping system for maximum heat transfer, this time using two screws for clamping instead of the one in E3D-v6.

This block absolutely cannot be used with a non Volcano nozzle, plastic will go everywhere, please don't try.


Compatibility

  • v5 and v6 Heater Blocks are cross compatible, both use an M6 thread. Note that v6 heater blocks are 0.5mm shorter than v5. 

Related Items