In stock, ready to ship.
As of 9/15/22, comes with new/improved heatercore (with blue thermistor insulation). Swap nozzles without complex tools and hot tightening with this innovative new HotEnd ecosystem from E3D, FDM 3D printing extrusion system experts.
Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.
Our special manufacturing process gives this aluminum HotEnd the strength and low thermal conductivity of titanium, without actually being titanium!
A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.
With an anodized black heatsink, not only does Revo Micro run cool – it looks cool, too.
Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.
- 1 x Revo Micro heatsink
- 1 x M12 x 1.5 nut
- 1 x 20 x 20 x 10 5V fan
- 1 x 12V or 24V to 5V regulator board
- 1 x Revo Micro fan duct
- 1 x Collet
- 1 x Collet clip
- 1 x Revo HeaterCore 12V or 24V
- 1 x Revo HeaterCore spring
- 1 x Extension cable kit
- 1 x 100mm PTFE
Single nozzle kit:
- 1 x 0.40mm brass Revo Nozzle
Fully loaded nozzle kit:
- 1 x 0.25, 0.40, 0.60, and 0.80mm brass Revo Nozzles
12V or 24V