Use this nozzle with the following materials:
In stock, quantities limited.
Nozzle is supplied with Nickel Coating.
Heat up the heat block up tp 280C, or at least above 250C, before removing or tightening any Bondtech CHT nozzle. Use at most 1.0 Nm torque.
They are manufactured by Bondtech in-house, and will fit the following hotends/blocks:
Bondtech CHT™ nozzles split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be used.
A nickel coating is applied to the coated Brass nozzles to provide protection against corrosion, erosion, and abrasion. Nickel-coated nozzles have more corrosion resistance and lower coefficient of friction, which allows slicker feeding of material and delays plastic adhesion to the nozzle’s surface.