In stock, ready to ship. Documentation can be found here.
Current Duex 5 version: v0.10.
The Duex 5 has the following features:
- 5 additional TMC2660 stepper motor drivers with stall notification.
- 5 additional extruder heater outputs.
- 5 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters. So you can use unused heater channels to drive servos.
- 5 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
- 5 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
- 4 uncommitted general purpose I/O pins.
- 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
- 5 additional thermistor inputs.
- Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
- Optional 5V external power input for powering servos, fans etc.
- Includes 50 pin cable and connector kit.
For more information see the Wiki.
As of May 12th, 2021, all Duet3D products purchased from Filastruder will be eligible for a 12 month limited warranty. For more information, visit http://www.duet3d.com/warranty.